Take the Lomey Dish and Pedestal and Glue together, leave to set.  Then using two shades of ‘Conwin Neon Foam Wire’ – pink and black twist them around the Pedestal very tightly spiralling up the pole leaving some loose at each end which you can curl once finished covering the Pedestal. 

Inflate using the Precision Air a cluster of 3.5” assorted colours of: Pearl Lavender, Pearl Magenta, Pearl Black and Metallic Silver and twist around the base of the Lomey Pedestal, sitting onto the dish.

Repeat Step 2 and make a couple more clusters, twist these clusters this time to the top of the Lomey Pedestal as a base for the next element.

Using the 10’ Extension Hose with Precision Plus Snap On connected to a Nitro Cylinder air fill the Clapper Board Foil and then tie into the top cluster as per pic.

Glue in some film accessories into the base, surrounded by some Microfoil Stars and Moons, then run some film ribbon through the design from the base to the top to create movement.

To complete the design an Ariel element was added! Using the Dual Split Second Sizer with the Insider Tool place 5” Assorted colours into the Diamond Clear 3’ Balloon, then inflate the 3’ and tie off to a line of Monofilament.   Now As in Step 2, inflate 4 clusters and  attach each under the 3’ spiralling the colours, to complete tie in 4 Crescent Microfoil Moons around the outside of this column created – under the 3’ (see pic) then tie the floating element into the base design at the height required to finish the Hollywood Table Design.

Material List:
1 x 31” Lomey Pedestal
1 x 11” Lomey Dish
Pink and Black Neon Foam Wire
6 x 5” Pearl Lavender
8 x 5” Pearl Magenta
5 x 5” Silver
3 x 4” Silver Foil Stars
2 x 9” Silver Foil Stars
2 x 9” Silver Foil Moons
1 x Hollywood Clapper Board Foil
Film Ribbon
Mini Clapper Board
Film Light
Lomey Glue
Glue Dots

Equipment Needed:
Auto Foil Outlet with Air
Heat Sealer