The support for this design is a 6’ Pole and base and ¼” Aluminium Rod.  Take the Ali Rod and start by securing it to the top (about 6” down from the top as you want to leave this clear until step 6) of the Pole (do not place the pole into the base just yet, it is easier to build the shape on the floor first) then following the pic bend the Ali Rod into the Cleft shape securing with duct tape at the points where the Ali Rod meets the Pole.   Take an additional small piece of Rod and add separately to the base of the pole as the Clefts flick, now place the pole into the base to complete the framework.

Take a 260Q Black and add a puff of air then without letting the air out place against the Cleft frame and then start wrapping the 260Q around the frame to covering (the air increase the coverage to 2” as you wrap) when you get to the end of the balloon, simply puff a second 260Q then cut the first letting the puff of air out, hold it to the frame and then take the second and start wrapping this one on, going over the end of the last to secure that in place, keep going until all the frame is wrapped.  

The framework is now to be covered with the balloons so using the Precision Air inflate clusters of 4 balloons from the 5” Black.  Start by adding the clusters to the central 6’ Pole – these are sized to approx 3” as you reach the curves you need to increase the size by ½” every few clusters, the maximum size to go to is 4.5” otherwise it is hard to sit the clusters neatly and then once the curve is over start to reduce the size back down again. 

Inflate a collection of 160Q White, and connect together to make a musical bar – with some music notes added.  Tie into the Cleft along the centre and at the base to add an extra affect to the design.

Once you have completely covered the frame with Clusters, balloon shine and sprinkle a touch of iridescent glitter over (whilst the balloon shine is wet) and leave in position.

Take the Confetti Cannon and fill the mini cylinder with Gas, then add the confetti to the barrel and seal with the foil – now connect the Cannon to the top of the Pole (where in step 1 you had left 6” Clear) at the back of the Cleft, weave the lead into the design and secure tightly Add a few additional small clusters to hide the cannon at the back to complete the design with a hidden impact!!

Material List:
8 x 260Q Black
Approx 5 Bags x 5” Black
15 x 160Q White
5 x 160Q Black
Confetti 

Equipment Needed:
Confetti Cannon
Aluminium Rod
Pole & Base
Duct Tape
Glue Dots