This design was supplied by: 
Simple yet stunning, this design looks amazing floating on a pond or pool – or simply hung on a wall!

STEP 1

Make a hole in the centre of the circular board (about the diameter of a pencil) and cut a slit in the edge about 1cm long.

STEP 2
Using Conwin’s Air Force 4 or Air Pro, inflate all of the curves with air. Hold all the 15” balloons together in a bunch and cable tie together close to the base of the body of the balloon. Repeat with the 19” curves.

STEP 3

Inflate the latex balloon to 6” (0.5 seconds on the Precision Air) and tie. 

STEP 4

Pull the tail of the latex balloon through the bunch of 15” curves, then through the bunch of 19”. Pass the lip through the hole in the board, pull to the edge and secure in the slit.

STEP 4

Lay the board on a flat surface and arrange the balloons as shown in the picture.